Weekly Roundup, 7.28.23

It’s been a quiet week on the project front; the heat outside has made things hard to accomplish after work.

That being said, I had a little free time last Friday and figured I’d try assembling the front bench to see if I could figure out how it worked. With a little trial and error, I was able to understand how the base and the rear go together, and measure for some hardware. The big question mark is how the seat attaches to the base itself. I remember Ray mentioning something about bolts coming up through the base into the seat but I can’t for the life of me understand how or what on the bottom of the seat they mate with. But knowing how the base is aligned makes a huge difference in the angle of the seatback.

The next step for this part will be grinding rust off the larger parts of the bare frame I’ve got and preparing it for foam, and then disassembling the seat. Having it in the truck, I realize the gray matches the steering wheel and dashboard, and I like how the black wraps around the top, down the sides, and scallops around the edges of the base. I’m leaning further towards having Jeff basically just match this pattern if possible. I did take a little time to wire-wheel the surface rust off the floors and shoot it with IH Red Rust-Stop, just to say I did something.

Last Monday I found a local metal supplier close to my town and attempted to navigate their website to figure out how much a sheet of plate steel would cost; eventually I gave up and called them. Surprised at how low the cost was for a 4×8’ sheet of steel, I ordered one and got off the phone. Later that day I realized I had no easy way of getting a 4×8’ sheet of steel home with the truck at the garage and no place big enough to easily store it, so I called back and canceled the order. Looking elsewhere, I found Onlinemetals.com and used their site to order three smaller (and more storage-friendly) sheets of 18 and 20 gauge steel. The sheet of 20 showed up Wednesday and it’s as beefy as I figured it would be; the 18 is still somewhere in transit. I went back and ordered a sheet of 16 gauge just to be safe, which will hopefully be here next week.

I heard back from IHPA on Tuesday, who couldn’t find the Travelall brake part I needed, but they pointed me to the Scout Connection. I called over there and within two minutes Dave had the part in hand and was taking my credit card information. From what he described it sounds like the right element, and I’m hoping it’ll be correct when it gets here later this week—I’d LOVE to get the brakes finally sorted and working, and then move on to the clutch.

Thursday I went to get the Scout from the shop it was sitting at for two weeks; they dicked around and never looked at it until I called and bugged them. In the meantime I struck up a conversation with a fellow Scout owner from Annapolis who recommended his mechanic, and I’ve got an appointment with him in the middle of August to drive it down and have him take a look. For now, it’s good to have my girl sitting under cover in the garage again.