After Day 2 of Hurricane Ophelia or whatever they’re now calling this blustery rainstorm that was supposed to have leveled the East Coast, I have a report on the repairs to the Travelall. In short, everything I did to the cowl looks pretty good. I saw one drop of water from the driver’s side vent opening that I haven’t been able to figure out yet, but the rest of the seams all look like they held well. Both of the floors are damp but I suspect that’s due to leaky door seals more than water coming through the cowl. There’s water along the sills in back as well which bears this theory out a little more. Along with the weatherstripping, Today I ordered a car cover so she can overwinter without getting wet, as well as postpone a hasty respray of the roof until the weather warms up and allows paint to dry and cure properly.
Sunday afternoon it was too rainy to be working outside but too warm to not be working. So I jumped the gun on my seat locker project and got started. In the garage, I tuned the radio to the Ravens game, then cut metal down and assembled the top of the cage first, knowing that the curves on the bottom would be difficult to assemble without it.
The rectangle went together smoothly, and I used the tailgate of the Scout as a level worktable to get everything squared up. I measured the height of the step again, cut four legs and tacked them into place. I’m not getting fancy with 45˚ butt-joint welds here because everything will get covered in sheet metal when this is complete.
Then I put spacers under the legs and looked at how the bottom of the cage would come together. The floor slopes down gently from the center, and the transmission tunnel sits in the center of that area. It’s a lot shorter than I envisioned, so my original design is being modified as I go. I don’t actually have enough vertical height for a length of tube spanning the front floor, so I have to cut legs that will tie into the upper bar.
I cut two short lengths of tube for the front side of the cage and tacked them into place just short of where the tunnel starts. With those in place I can gauge the angles I’ll need to cut the legs up to the top tube. I’m going to leave the bottom of the cage off in back, and weld in some tabs that can mount directly to the step wall.
By 7PM I was losing light, and couldn’t work in the truck anymore, so I cut two short lengths and tacked them in across the top of the cage where they’ll be the supports for a set of piano hinges.
The next step will be dragging the welding gear out to the driveway, putting weight on the cage, and tacking scrap metal to the open end of each bottom bar. From there I can get a proper idea of the angle for the legs, cut them down, and weld them in. Then two tubes go at the bottom of the thin sides to complete the boxes. I’ll cap off the open ends of the tubes and grind everything down smooth, and then start bending sheet metal.