I think the roof project on the Travelall is done. I scuffed and wet-sanded the first coat of paint on Sunday with 1500 grit paper, which basically knocked the shine down. From there I hit it with a tack cloth and prepped the tent for shooting paint. Because I was so wiped out from a trip to my FiL’s place on Saturday I didn’t really have the energy to do much more—I did re-splice the second wire off the large bulkhead connector to restore my marker lights but not the flashers, and I spent some time sanding and fixing the shitty peeling clearcoat and scratches on the drivers rear quarter panel. Those got a coat of rattle can international red which should keep them covered and protected for the time being.
Monday morning I put the tarps up around the ghetto tent, taped and papered off the entire truck, and got everything ready to shoot the second coat of white paint. I used more of it on the first coat that I had for the second, so I had to be careful in my application. I was able to cover the entire roof starting from the middle section out and I think I got good coverage. I probably could have dialed the gun in a little bit better – if I had a little more paint, I would have dialed it thicker. I think the air/paint mixture was a little too dry, and so it went on with a little more texture than it should have. But the whole thing is covered and I’m happy to have that part of the project behind me. I’m going to see how it weathers over the winter, and if it’s really sloppy and looks bad, I’ll wet sand the whole thing again, buy another can of the paint, and spray a solid second coat over it.
While that was drying, I turned my attention to the Scout. I drove it out of the garage over a tarp and pulled the fill plug out of the transmission. Nothing came out, so I drained the entire case. Then I dug out my fill pump and my last two cans of 50W racing oil. After pumping both of those into the case, it’s pretty clear there wasn’t 3 1/2 quarts still in it—I’m actually quite certain of that. Nobody had 50 weight racing oil around here locally so I ordered some from Amazon, which should be here on Wednesday. The next thing I’ve gotta find is a new PCV valve to replace the one on the truck. If that’s clogged, the pressure inside the crankcase was too high, and it may have blown the seal out of the back end of the transmission. But, I’m going to fill the case and drive it a bit to see if it’s still leaking very badly.