Up in New York State to visit my family this Thanksgiving weekend, I reconnected with a guy near my sister’s house who has a lot full of antique iron in some fields off a back road. He’d advertised a Travelette late last year which I was interested in picking over but when the green truck landed in my lap, my plans changed. In February he said he also had a ’62 Travelall panel van in rough shape (he sent me a few pictures) so I figured I’d take a few hours and finally go check it out (the Travelette has since been purchased). I packed my standard recovery kit: tools, torch, PBblaster, impact gun, pry bars, and cold weather gear. I also bought a cordless angle grinder based on previous experiences, but left it in the box in case I didn’t need it.
If you didn’t know where to look for his yard you’d never find it, but what a collection he’s got. He’s heavy into Studebaker, Willys, and old Chevrolet, but there are all different makes sprinkled in. After carefully edging past an ancient Hudson, we cut some brush back and crawled through a hole in the fence to reach the truck.
It was beached next to a dually 50’s Chevrolet truck and a bathtub Nash that was sinking backwards into the dirt. The Travelall was well-used and picked over pretty good, so there wasn’t much to see there; I grabbed marker lights, the rear barn door handle (now I can soak this, disassemble it, and rekey it for the red truck) and the ’62 grille and headlight surrounds, which are in very good shape. The steering column was completely gone as was the manual box, so that was a bust.
I walked through the section I was in and came upon a ’68 pickup with a cap in very good shape. Both doors were inaccessible so I couldn’t get into the cab, and lifting the hood revealed column-shift manual steering, so I didn’t go for that. But the sheet metal on the front clip was in miraculously good shape. Both turn signal buckets were solid and the metal behind them was too, so I talked with the owner and made a deal on the entire nose. He agreed to let me cut it out as opposed to trying to remove all the fasteners (both of the fenders were garbage in the usual C-series way).
So I unfastened what I could, pulled the radiator and drained it for him, and cut both sides out as carefully as possible. I found that my normal-sized 20V batteries weren’t big enough to keep the grinder going for long, so I’ll have to get a pair of larger ones when these are worn out.
After about an hour I had the sheet metal free from the truck but had to cut the bottom mount bolt out to get it around a big homemade bumper. This took several trips back and forth to the garage, where he had my charger on a long extension cord. Then I had to jimmy the clip backwards to scoot it under the top lip of the same bumper. With that out, and a set of perfect taillight buckets, I hauled my finds back to the car and gave him my cash.
He then took me on a quick tour of the collection, where he’s got even more stuff across the street in another field, including a beautiful old cabover IH tractor, several C-series pickups, and a B-series Travelall that used to be a civil defense vehicle. There were rows and rows of Studebakers, a beautiful porthole Buick, Packards and Nashes and a Morris Minor minus its convertible top. The collection went on forever. These kinds of yards are all but extinct up here in salt country, so being able to spend at least five hours there on a snowy Friday was a lot of fun.
As for my new parts, the top of this nose is in rough shape, but I should be able to graft the bottom on to my existing sheet metal. The area around the turn signals on my truck is the worst rust besides the cowl vents I repaired last summer, so having some good metal to work with was worth the effort. I’ve got several taillight lenses, a perfect bucket, and several front lenses. And the ’62 grille and matching dual-light surrounds. All in all, not a bad haul.