Sunday was a day of tying up some loose ends from the last couple of weeks in between snowstorms. We’re supposed to be getting a major accumulation this coming week so I wanted to get in under the cover, get some stuff buttoned up, and prep it for the weather.
First off, I drilled holes in the cupholder mount and the seat base and installed it with a couple of 5/16″ bolts. I’ve been waiting to do that for a long time, and it really looks good there—even in etching primer. I’m toying with the idea of taking it to be powder coated in black for some added durability.
I grabbed the bracket for the fuel filler hoses, pulled the fender off, and took some time to install it, the new hose, and a refurbed filler cap ring on the temporary fender. It all fit well, with the hose from the tank being maybe 1″ too short on the long side, but it’s good enough to reach the filler neck. So everything is ready for when the good fender gets sprayed and is ready to install permanently.
Then I used some zip ties and a wire holder to tidy up the fuse panel install from last weekend, moving the jumper wire up behind the heater plenum and directing the bundle from the panel upwards and out of the footwell. That made a big difference behind the pedals.
In the garage I fished out a sheet of 18 ga. steel, traced the pattern I built last weekend for the seat mount out, and cut it down with the angle grinder. When it was roughed out, I trimmed the sides down on the bench grinder and prepped it for the brake. I don’t know when I’ll get back out to Brian’s again but that will be another good project to dive into.
Finally, I wire wheeled the last three headliner bows and cleaned them up for etching primer. All five are now ready for a coat of the interior gray I used on the door cards, which will have to wait until springtime.